Analyze the reasons for the skipping edge of the slitter

The slitting machine has stretching, the tension of the rewinding and unwinding is not well controlled, and the winding is as automatic as possible The tension is relatively constant. If the slitter has a skipping edge, it may be that no maintenance work has been carried out.

In order to ensure that the slitting machine is always in good technical condition, it can be put into operation at any time, reduce the downtime days, improve the mechanical integrity rate and utilization rate, reduce mechanical wear, prolong the service life of machinery, and reduce the cost of mechanical operation and maintenance To ensure safe production, it is necessary to strengthen the maintenance of mechanical equipment.

The maintenance of the slitting machine must implement the principle of "paying equal attention to maintenance and prevention", so that regular maintenance and compulsory maintenance are carried out, and the relationship between use, maintenance and repair is correctly handled.

The maintenance of the slitting machine should ensure the quality, and be carried out item by item according to the specified items and requirements, and no warranty or non-guarantee shall be omitted. Maintenance items, maintenance quality and problems found in maintenance should be recorded and reported to the department.

Each team must do a good job of maintenance work of all kinds of machinery according to the mechanical maintenance procedures and maintenance categories, and shall not be unreasonably delayed. If the above points are done, the probability of the slitting machine jumping edge will be reduced a lot.